A06B-6082-H215#H511  FANUC 主轴放大器模块 主轴放大器SPMC-11 I型

如果您需要更多详细信息，请联系我们：sales@xiongbagk.cn（点击！！

A06B-6088-H222#H508

The current in the DC part (DC link) of the main circuit is too large.
In SPM-11i, the power (IPM) of the main circuit is abnormal. The abnormal content is excessive current or overload. (1) When the alarm is displayed in SPM-11i
Please also confirm the corresponding content of alarm code 09. (2) Installation problem of control substrate
Please press down the panel (if the connector connecting the control substrate to the power substrate deviates, an alarm may be raised). (3) When the alarm occurs after the spindle rotation instruction is given
(a) Bad motor power line: Please confirm whether there is short circuit or ground fault between the motor power lines, and replace the power line if necessary. (b) Poor motor insulation: please replace the motor when the ground fault occurs.
(c) The motor’s inherent parameters are not set correctly: please confirm the motor’s inherent parameters.
(d) Poor SPM: The power component (IGBT, IPM) may be damaged. Replace the SPM. (4) Alarm occurs in the process of spindle rotation
(a) Power component damage: It may be power component (IGBT, IPM) damage. Replace the SPM. Power components may be damaged due to insufficient dust accumulation and cooling in the cooling device part of the amplifier.
If the heat dissipation device on the back of the amplifier is dusty, clean it by blowing air. The structure should be studied so that parts of the cooling device do not directly contact the cutting oil, etc.
(b) The motor’s inherent parameters are not set correctly: please confirm the motor’s inherent parameters.
(c) Abnormal speed sensor signal: please confirm the signal waveform of the spindle sensor, if abnormal, please adjust, or replace the detection part. 15 Alarm code 15
The program is not executed correctly when switching operation of output switching control or spindle switching control.
The time from the change of switch request signal (SPSL or RSL) to the change of power line status confirmation signal (MCFN, MFNHG or RCH, RCHHG) is more than 1 second
When, an alarm occurs.
(1) Troubleshooting when alarm occurs
(a) Bad surrounding of the electromagnetic contactor (switching device) for power line switching

我们的服务A06B-6082-H215#H511  FANUC 主轴放大器模块 主轴放大器SPMC-11 I型

1.交货港：中国厦门

2.联邦快递，顺丰快递，京东快递，德邦快递，

3.库存，立即发货

4.所有产品均为全新原包装盒。

5.我们将用泡沫将所有货物包装在一个纸箱中，以抗震。

6.一旦我们发货，您将获得尺寸和重量。