CI502-PNIO 1SAP220700R0001 PROFINET通信接口模块

CI502-PNIO

The PROFINET® Bus Module CI502-PNIO is used as decentralized I/O module in PROFINET® networks.
The network connection is performed via 2 RJ45 connectors which are integrated in the Terminal Unit. The Bus Module contains 24 I/O channels with the following properties:
n 8 digital configurable inputs/outputs in 1 group (1.0…1.7)
n 8 digital inputs 24 V DC in 1 group (2.0…2.7)
n 8 digital outputs 24 V DC in 1 group (3.0…3.7)
The inputs/outputs are electrically isolated from the Ethernet network. There is no potential separation between the channels. The configuration of the configurable digital inputs/outputs is performed by software.
For usage in extreme ambient conditions (e.g. wider temperature and humidity range), a special XC version of the device is available.

n 8 digital inputs 24 V DC
n 8 digital outputs 24 V DC, 0.5 A max.
n 8 configurable digital inputs/outputs 24 V DC, 0.5 A max.
n Module-wise electrically isolated
n Fast Counter
n XC version for usage in extreme ambient conditions available

The Ethernet Bus Module CI502-PNIO is plugged on the I/O Terminal Unit TU507-ETH or TU508-ETH. Properly seat the module and press until it locks in place. The Terminal Unit is mounted on a DIN rail or with 2 screws plus the additional accessory for wall mounting (TA526).
The electrical connection of the I/O channels is carried out using the 30 terminals of the I/O Terminal Unit. I/O modules can be replaced without re-wiring the Terminal Units.

The terminals 1.8 and 2.8 as well as 1.9, 2.9 and 3.9 are electrically interconnected within the Terminal Unit and have always the same assignment, independent of the inserted module:
Terminals 1.8 and 2.8: Process supply voltage UP = +24 V DC
Terminal 3.8: Process supply voltage UP3 = +24 V DC
Terminals 1.9, 2.9 and 3.9: Process supply voltage ZP = 0 VThe assignment of the other terminals:

The following figure shows the electrical connection of the configurable digital input/output DC0 and DC1. DC0 is connected as an input and DC1 is connected as an output. Proceed with the configurable digital inputs/outputs DC2 to DC7 in the same way.