DS200FGPAG1A Gate脉冲放大器板 DS200CPCAG1ABB

DS200FGPAG1A

Part No.: DS200FGPAG1A
Manufacturer: General Electric
Product Type: Gate Pulse Amplifier Board
Series: Mark V

Power is delivered to one phase of an SCR bridge on the GE Gate Pulse Amplifier Board DS200FGPAG1A, cell voltage data is gathered, and AC to DC control voltage is transformed.
The DS200FGPAG1A board features one sending fiber optic port and 14 receiving fiber optic ports for an extremely fast and stable network.

• Duplex fiber optic networks are served by two receiving ports, whereas simplex fiber optic networks are served by the remaining ports. Because electrical interference does not impact the messages, fiber optic networks are highly helpful in an industrial environment. As a result, fiber optic cables can be used in conjunction with 3-phase power cables or any other wire.
• Fiber optic links can also extend further than copper wire networks. If repeaters are added to the networks, the runs can be even longer. The length can be doubled by using repeaters. A maximum of two repeaters can be added to the network. When designing fiber optic cable routes, make sure the bend radius does not exceed the specifications’ recommended radius. They may have degraded the transmission or destroyed the cables if they were tighter. The signal power can be reduced or increased to configure the fiber-optic network. This is determined by the length of the fiber optic cable as well as other factors.
• The board is subject to harm by static electricity. Keep the board in its protective container until you’re ready to install it to reduce the risk.