IS200EISBH1AAC 阿格Mark VI电路板 在EX2100励磁模块中用作励磁机ISbus板

IS200EISBH1AAC是阿格Mark VI电路板。该板通常在EX2100励磁模块中用作励磁机ISbus板。该板负责管理其机柜内的光纤通信。

IS200EISBH1AAC配有一个前面板，该面板包括两个定位销，一旦将板安装到机架系统中，这些定位销会将板锁定到位。这些都标有电路板id号和通用电气公司的标志。在这两者之间，板有一个开口，以访问复位开关(实际上位于板的表面)和几个光纤连接器。光纤连接器标有发电机磁场电压和电流、励磁机电压和电流以及接地检测输入和输出。面板用螺钉连接到电路板上。

电路板上标有几个代码和条形码。它是工厂沿其边缘在几个位置钻孔。该板还标有通用电气公司的标志。

组件标有参考标记。该板有二十多个集成电路。它有电感线圈、电阻、电容、几个晶体管和二极管，以及前面提到的复位开关。该板还有两个小型变压器和一个背板连接器，用于光纤反馈信号的输入和输出。

IS200EISBH1AAC

The IS200EISBH1AAC is a GE Mark VI circuit board.  The board is typically used in EX2100 excitation modules as an Exciter ISbus board.  This board is responsible for managing fiber-optic communications within its cabinet.

The IS200EISBH1AAC is built with a front faceplate that includes two set pins that lock the board into place once it has been installed in the rack system.  These are marked with the board id number and with the General Electric logo.  In between these, the board has an opening to access a reset switch (actually located on the board’s surface) and several fiber-optic connectors.  The fiber optic connectors are labeled  Gen Field voltage and current, Exciter voltage and current, and Ground Detect In and Out.   The faceplate connects to the circuit board using screws.

The circuit board is marked with several codes and barcodes.  It is factory-drilled along its edge in several locations.  The board is also marked with the GE logo.

Components are marked with reference designators.    The board has over twenty integrated circuits.  It has inductor coils, resistors, capacitors, several transistors, and diodes, as well as the aforementioned reset switch.   The board also has two small transformers and a single backplane connector that is used for both inputs and outputs of fiber-optic feedback signals.