SDCS-PIN-H01 DCS晶闸管功率变换器 直流驱动系统

SDCS-POW-4-COAT

The matrix below indicates all available product documentation and its corresponding order numbers on its left columns as well as all existing DC Drive systems on its top rows. System descriptions, Technical data and Operating instructions (as far as they are available for the corresponding drive) are the basic documents and will be delivered together with each drive. All other documentation has to be ordered separately.

Generalremarks
The term “DCS thyristor power converter” is a general designation for basic DC converters from ABB. This termcan be found in many parts of the relevant documentation. The precise product name in accordance with thebrief descriptions given below characterizes a specific unit.
Brief description of DCS 500 and DCs 500BThe DSC 500B unit range is an enhancement developed from the DcS 500 range. The difference between thetwo ranaes lies in the version of the control board: the control board used for the DCS 500B unit range is theSDCS-CON-2 type, which is different from the SDcS-CON-1 type in several points (see the table below).
Brief description of DCP 500 and DCP 500BIn the DCP 500 unit, the electronics of the DCS 500 unit have been equipped with a different power section.which changes its visual appearance, its installation dimensions and the interface between the power sectionand the electronics. The DCP unit is functionally compatible with the DCS unit, since the electronics (powerpack, control board and options and/or control) are identical. The DCP 500B unit range is an enhancementdeveloped from the DCP 500 range, with the difference between the two ranges lying in the control board: thecontrol board used for the DCP 500B unit range is the SDcS-CON-2 type, which is diferent from the SDcSCON-1 type in several points (see the table below).

Brief description of DCF 500BWith software release 21.232 or higher DCS 500B has a ‘3-phase field exciter mode”. A DCF 500B is a three.phase field exciter based on the programmable DCS 500B software and the SDCS-CON-2 control board.The interface boards PlN-1x/PlN-2x are modified, . an overvoltage protection unit DCF 505/506 is required.
Brief description of DcS 600
The DCS 600 converter family is based on the hardware developed for the DCS 500B type.Instead of a COM-x board, the SDCS AMC DC board is used. PC tools will be connected there. as well asthe APC (Application controller), if the APC is used as a PLC. lf a diflerent PLC is used, separate adaptermodules are needed. They must be connected to the AMC-DC board, too. The software code always beginswith S15.xxx for MultiDrive or S18.xxx for Crane drives.
Brief description of DCF 600The DCF 600 unit range is intended to be used for supplying motor fields and is based on the hardware andsystem configuration of the DcS 600 unit. The software is identical to the DCS 600 software. Similar to DCF500 units the DCF 505/506 overvoltage protection unit is required. The same modification is applied to thePIN-1xPIN-2x boards, compared to DCF 500.
Brief description of DCs 400
The DCS 400 is the smallest drive in its class. The compact design has been partly achieved by a fully integratedfield exciter based on lGBT technology. A commissioning wizard – available on the control panel and the POtool – makes start-up of the drive easy. In addition, the DCS 400 contains application macros.